Pipe Solve
Offline availability has not been verified.
General Calculator
Standard Offset
Layout Results
Measurement References
Standard and Rolling C-C
Travel is between theoretical intersections of extended straight fitting centerlines, not physical elbow arc centers or weld faces. Run is parallel to the incoming pipe axis. Rolling rise and roll combine into true offset; plane rotation is measured from roll toward rise.
These two geometry tools do not calculate cut lengths or fitting takeoffs. A solved angle does not establish fitting availability.
Arc Length
Use the actual radius of the surface being measured. Outside radius is actual outside diameter divided by two, not nominal pipe size.
Mitred Fitting Takeoffs and Ordinates
Cut down a standard long-radius 90° elbow. Select a supported nominal pipe size; the preset supplies the actual outside diameter and centerline radius. Enter the remaining fitting angle, not the removed angle or saw setting. Surface arcs start at the retained original end face.
Offline Storage
Wait for “Ready offline” before disconnecting. Reopening this same address uses the saved app. Browser storage can be cleared or evicted; private browsing may not retain it. Recheck readiness after reconnecting. Entered measurements and History are kept only while this page is open; reload restores calculator defaults and empty History. Only Fraction Precision is saved on this browser. Updates activate after all open app tabs close, preserving the current complete version while you work.